Setting Up Your Microphone With Pivot Mount & Desk Stand - Audio Technica ATR2100x-USB User Manual

ATR2100x-USB Setup
USB-A USB-C
Bottom of microphone
Screw the microphone stand clamp onto the
1
threaded portion of the desk stand. The front of the
microphone should be facing the A-T logo on the
desk stand.
Install the microphone into the stand clamp, with
2
ON/OFF switch facing up.
Extend the tripod legs to provide a wide, secure
3
base, and place the tripod desk stand on a flat
surface.
Use a screwdriver or coin to loosen/tighten the
4
pivot screws for angle adjustment.
For digital use, plug one of the provided USB
5
cables into the base of the microphone then
connect the other end of the cable to your digital
recording device.
USB-C
XLR
Headphone volume
3.5 mm (⅛") headphone output
XLR
When connecting the microphone to a USB-C port,
you must use a USB On-The-Go (USB OTG) cable
like the one included.
For analog use, plug the provided XLR cable into
the base of the microphone then connect the other
end of the cable to your analog audio device.
When using with equipment that includes a
6
built-in mic, consult that device's user guide for
instructions on disabling its mic.
Optional headphone monitoring: Connect
headphones with 3.5 mm (⅛") plug into base of
microphone. Use the dial to control volume.
Stand clamp
Tripod desk stand
3