Table of Contents
Advertisement
ATR2500x-USB Setup
USB-A
USB-C
For desktop use
1
Screw the microphone into the threaded portion of
the tripod desk stand. The front of the microphone
should face the A-T logo. Extend the tripod legs to
provide a wide, secure base, and place the tripod
desk stand on a flat surface.
For mic stand use
Screw the microphone stand clamp to your mic
stand. Screw microphone into the stand clamp.
Use a screwdriver or coin to loosen/tighten the
2
stand's pivot screws for angle adjustment.
Plug one of the provided USB cables into the USB
3
output at the base of the microphone then connect
the other end of the cable to your digital recording
device.
Headphone volume
3.5 mm (⅛") headphone jack
When connecting the microphone to a USB-C port,
you must use a USB On-The-Go (USB OTG) cable
like the one included.
When using with equipment that includes a
built-in mic, consult that device's user guide for
instructions on disabling its mic.
Optional headphone monitoring: Connect
4
headphones with 3.5 mm (⅛") plug into front of
microphone. Use up/down buttons for volume
control.
Stand clamp
Tripod desk stand
3
Hide quick links:
Advertisement
Table of Contents
