Vaxcel T0503 Assembly And Installation Instructions

ASSEMBLY AND INSTALLATION
T0503
WARNING:
N O T E : S . 1 B e o f e r n i
2. READ AND SAVE THESE INSTRUCTIONS.
Hardware Package (included):
Wire Connector (B)
Fitter Screw (A)
Installation Steps
Turn off the power at fuse or circuit box
1. Unscrew the metal frame and the set screws on
the bottom frame. (Fig.1)
2. Make the bottom of the fixture upward, gently
place four glass panels into the metal frame,
then press the clips to secure the glass panels. (Fig.2)
Metal
Frame
Set Screw
Bottom
Frame
3. Install a bulb (not included). See relamping label at socket area or packaging for maximum allowed wattage.
4. Pull out the wires and grounding wire from the post. Make wire connections using the wire connectors (B):
---The black wire from the fixture to the black wire from the post.
---The white wire from the fixture to the white wire from the post.
---The grounding wire from the fixture to the grounding wire from the post.
Carefully put the wires back into the post.
5. Place the fitter on the post, then secure it with the fitter screws (A).
CAUTION: With silicone caulking compound, caulk completely around where the fitter meets with the post
surface to prevent water from seeping into the post.
Turn on the power at fuse or circuit box
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
s a t l l n i , g c o n s u t l o l c l a
Glass Panel
Clip
Metal
Frame
Fitter
Fig.1
e e l c r t c i l a c o d e s f r o w
Photocell
Fig.2
r i n i g a n d g o r u n d n i g
Bulb Type A Max.60W
(not included)
Fitter
Fitter Screw (A)
Fixture Wire
Wire Connector (B)
Grounding Wire
Post
e r q i u e r m e t n . s
Metal Frame
Glass Panel
181212