Pioneer PDP-6010FD Service Manual page 92

1
6.2.1.5 TEMPERATURE
A
A present temperature and the FAN rotation are displayed.
If either [k] key or [l] key is pressed, the display data is refreshed.
1
5
10
B
15
16
• Display/Meaning
TEMP1 : The temperature of the sensor on the panel side is displayed by the Fahrenheit (F).
TEMP2 : The temperature conversion display is done with 10 bit the A/D input value of IF uCOM 90 pin (AN4). It is displayed by
both the Fahrenheit (F) and 8 bit A/D value.
(Remark:When temperature (F) of the sensor becomes more than a specified temperature, the shutdown start of processing.)
FAN1 : The value of the FAN rotating state is displayed.
C STOP: stopped, LOW: slow speed, HIGH: high speed.
FAN2 : The value of the rotation state of FAN is displayed.
During a rotation of FAN, 8bit D/A value output from 2 pin (DA0) of IF uCOM is displayed.
It is displayed with OFF during a stop (only for the FHD model).
B-SENSOR : The value that indicated the degree of brightness input into an Room light sensor is displayed.
AD value when the output of the Room light sensor was input into 89 pin (AN5) of IF uCOM is displayed.
D
E
F
92
1
2
1 5 10 15
I N F O R M A T I O N
T E M P E R A T U R E
T E M P 1 : 1
T E M P 2 : 1
:
F A N 1 L
:
F A N 2 –
:
B – S E N S O R 1
PDP-6010FD
2
3
20 25 30
V D 1 – 3 0 6 0 1 – N T V – A H
0 4 . 3 ( F )
0 4 . 3 ( F ) 1 3 0 ( A / D )
O W
– –
0 2 3 ( A / D )
3
4
35 40
B
4