One-Time Bypass - Viper 3000 Owner's Manual

The in-vehicle status LED will light solidly if you are entering
Valet Mode, and it will go out if you are exiting Valet
®
The remote responds with the normal arm notifications with
each remote button press.
➜

one-time bypass

This feature stops the alarm from arming or activating any
outputs that are programmed to activate when the alarm is
armed.
One-time bypass will defeat the following actions:
Passive arming: If programmed ON the alarm will not arm
itself.
If the remote is used to arm the alarm after exiting the vehicle:
Window roll up: If programmed ON this output will not
activate.
Linked Auxiliary Outputs: If programmed to activate on
arm, they will not activate.
To activate one-time bypass:
1. After parking turn the ignition off.
2. Turn the ignition On for more than 1-second and less than
3-seconds.
3. The siren will chirp once to indicate one-time bypass has
been activated.
To cancel one-time bypass perform one of the following:
Arm then disarm the alarm.
Turn the ignition On for more than 3-seconds.
26
Mode.
®
© 2005 directed electronics, inc.