One-Time Bypass; Nuisance Prevention ® Circuitry - Viper 5000 Owner's Manual

➜

one-time bypass

This feature stops the alarm from arming or activating any
outputs that are programmed to activate when the alarm is
armed.
One-time bypass will defeat the following actions:
Passive arming: If programmed ON the alarm will not arm
itself.
If the remote is used to arm the alarm after exiting the vehicle:
Window roll up: If programmed ON this output will not
activate.
Linked Auxiliary Outputs: If programmed to activate on
arm, they will not activate.
To activate one-time bypass:
1. After parking turn the ignition off.
2. Turn the ignition On for more than 1-second and less than
3-seconds.
3. The siren will chirp once to indicate one-time bypass has
been activated.
To cancel one-time bypass perform one of the following:
Arm then disarm the alarm.
Turn the ignition On for more than 3-seconds.
➜
nuisance prevention
Your system has Directed's Nuisance Prevention
(NPC ). It prevents annoying repetitive trigger sequences due to
®
32
® circuitry
© 2005 directed electronics, inc.
Circuitry
®