Viper 3000 Owner's Manual page 37

is not used (ignition is not turned on) for a period of one
hour while the system is in Valet
off. If the system remains in Valet
come back on the next time the ignition is turned on and
then back off.
p p r r o o g g r r a a m m m m i i n n g g
Programming options control what your system does during
normal operation, and require few or no additional parts.
However, some may require additional installation labor.
The following is a list of the program settings, with the factory
settings in B B o o l l d d : :
➤ A A c c t t i i v v e e a a r r m m i i n n g g (only with the remote) or passive arming (au-
tomatic arming 30-seconds after the last door has been
closed).
➤ Arming/disarming confirmation siren chirps o o n n or off.
➤ The ignition controlled door lock feature o o n n or off: With
this feature on, the doors will lock three seconds after the
ignition is turned on, and the doors are closed, and unlock
when the ignition is turned off. The system will not lock the
doors when the ignition is turned on with any door open. If
your installer is programming the security system with the
Directed Bitwriter, ignition lock and unlock are indepen-
dent features and can be programmed separately.
➤ Passive door locking (with passive arming) or a a c c t t i i v v e e d d o o o o r r
l l o o c c k k i i n n g g (only when arming with the remote). Passive locking
38
Mode, the LED will shut
®
Mode, the LED will
®
© 2005 directed electronics, inc.