Remote Controlled Valet Mode; False Alarm Control Technology (Fact) - Directed Electronics Matrix 3 Owner's Manual

The LED status indicator will light steadily if you are entering
Valet Mode and will turn off if you are exiting Valet Mode.
➜

remote controlled valet mode

The operations described in this section refer to transmitter
buttons. Remember, the buttons used in all the instructions in
this guide correspond to a Standard Configuration transmitter.
This may not be how your transmitter is set up.
1. Open any vehicle door.
2. Press .
3. Press .
4. Press again.
The LED status indicator will light solid if you are entering Valet
Mode, or will go out if you are exiting Valet Mode.
➜

false alarm control technology (FACT)

Your system offers FACT, a feature that prevents annoying repet-
itive trigger sequences due to faulty door pin switches or
environmental conditions such as thunder, jackhammers,
airport noise, etc.
Here's how it works: The alarm triggers three times. Each time,
the same sensor or switch is triggering the alarm. The three trig-
gers are within 60 minutes of each other. FACT will interpret
this pattern of triggers as false alarms. After the third trigger,
12
© 2001 directed electronics, inc.