Arming While Driving - Directed Electronics Matrix 3 Owner's Manual

➤ ➤
Pressing the arm button a second time within five seconds:
The siren chirps twice followed by a long chirp. Zone Two is
now bypassed.
➤ ➤
Pressing the arm button a third time within five seconds:
The siren chirps three times followed by a long chirp. Zone
Four is now bypassed.
➤ ➤
Pressing the arm button a fourth time within five seconds:
The siren chirps four times followed by a long chirp. Zones
Two and Four are now bypassed.
➤ ➤
Pressing the arm button a fifth time within five seconds: The
siren chirps five times followed by a long chirp. All input
zones, except the ignition, are now bypassed.
note: Multi-Level Security Arming only applies to a
single arming cycle. Once the system is disarmed and
then re-armed, all the zones will be active again.
➜

arming while driving

Your system can be armed while driving the vehicle! Simply press
on your transmitter for 1.5 seconds while the vehicle is
running or while the ignition is on. The siren will chirp once and
then once more to indicate that the ignition is on. The security
system will not respond to any input except the door triggers and
the starter interrupt relay (if installed) will not be activated. The
system will disarm automatically whenever the ignition is turned
off. The siren will chirp twice and the LED will stop flashing.
8
© 2001 directed electronics, inc.