Table of Contents
Advertisement
Add or remove remote controls.
Change PIN code.
Custom configure the remote control.
Remote valet on or off.
Autostart with low battery voltage or cold temperature.
cliffnet wizard installation software programming
Cliffnet Wizard provides access to all available system features and
some that are not available when manually programming with the
Valet switch. Cliffnet Wizard is compatible with Microsoft Windows
95/98/2000/ME/XP/NT so most programming operations can be
accomplished by pointing and clicking with a mouse. This eliminates
the need for programming grids and lengthy programming sequences.
For a complete guide to system programming using the Cliffnet Wizard
refer to the Cliffnet Wizard help menu.
manual programming instructions
Be sure to document changes by taking note of all feature changes
made in programming mode.
To enter the User Selectable Features programming:
1.
Ignition on - Turn the ignition to the run position or start the
engine.
2.
Enter PIN - Enter the factory preset PIN code 2 by pressing
on the PlainView 2 Valet switch twice, then
20
once.
Advertisement
Table of Contents
