Remote Control - Chamberlain Contractor Series Manual

Operation

Remote Control

Your remote control has been programmed at the factory to operate with your
garage door opener.
Older LiftMaster remote controls are NOT compatible, see page 45 for compatible
accessories. Programming can be done through the door control or the learn button the
garage door opener. To program additional accessories refer to the instructions provided
with the accessory or visit LiftMaster.com. If your vehicle is equipped with a Homelink
you may require an external adapter depending on the make, model, and year of your
vehicle. Visit www.homelink.com for additional information.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN
USING THE PUSH BUTTON DOOR CONTROL - MODEL 882LMW
1. Press the LEARN button on the door control twice. The Command LED will blink.
2. Remote Control:
Press the button on the remote control that you wish to operate your garage
door.
Keyless Entry:
Enter a 4-digit personal identification number (PIN) of your choice on the keyless
entry keypad. Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) and the Command
LED will stop blinking when the code has been programmed. Repeat the steps above for
programming additional remote controls or keyless entry devices. If programming is
unsuccessful, program the remote using the learn button.
1
LEARN button
2
Command LED
OR
? ? ? ?
PIN
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN
USING THE MULTI FUNCTION DOOR CONTROL - MODEL 883LMW
1. Press and hold the LIGHT button and the push button until the push button LED
begins to blink.
2. Remote Control:
Press the button on the remote control that you wish to operate your garage
door.
®
,
Keyless Entry:
Enter a 4-digit personal identification number (PIN) of your choice on the keyless
entry keypad. Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when the code has
been programmed. Repeat the steps above for programming additional remote controls
or keyless entry devices. If programming is unsuccessful, program the remote using the
learn button.
1
Push Button
2
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL USING THE LEARN
BUTTON
1. Press and release the LEARN Button on the garage door opener.
2. Press and hold the button on the remote control that you wish to use. Release
the button when the garage door opener lights blink or two clicks are heard.
1
40
LIGHT/LEARN Button
OR
? ? ? ?
PIN
2
LEARN
Button
LEARN LED