Disarming; Transmitter - Directed Electronics Automate AM1 Owner's Manual

disarming

To disarm the system, unlock the doors using your factory keyless trans-
mitter. The horn will sound twice, and the parking lights will flash
twice. If the horn sounds either four or five times when disarming, refer
to the Diagnostics section of this guide. This is called Tamper Alert.
disarming without a transmitter
This feature allows you to override the system without the transmitter
should it be lost, damaged or disabled. To do this, you must have the ve-
hicle's ignition key and know where the integrated LED/Valet
located. The Valet ® switch is activated by pressing the LED status indicator.
Integrated
LED/Valet ® switch
Turn the ignition to the "run"position.
Press
LED/Valet
After a few seconds the LED will stop
flashing and the vehicle should start. If it does not, you may have waited
too long. Turn the ignition off and try again.
n n o o t t e e : : The setting for the number of times the integrated
LED/Valet® switch must be pressed is set in the
Programming Section of this guide.
© 2005 directed electronics, inc.
and release the integrated
® switch, within 10 seconds.
® switch is
LED status indicator
DRW-35
5