each time it is disarmed, until the next time the ignition key is turned on.
table of zones
The zone number is the number of LED flashes used by the system to
identify that input. The standard input assignments are listed below.
Z Z O O N N E E
(Number
LED Flashes)
1 1
2 2
3 3
4 4
5 5
The LED will not report if the Warn Away response is triggered.
rapid resume logic
This system will store its current state to non-volatile memory. If power
is lost and then reconnected the system will recall the stored state from
memory. This means if the unit is in Valet
connected for any reason, such as servicing the car, when the battery
is reconnected the unit will still be in Valet
states of the system including arm, disarm, and Valet
10
D D E E S S C C R R I I P P T T I I O O N N
Instant trigger - often used
for hood/trunk pin switches
Instant trigger - a heavier impact
detected by the shock sensor
Door switch trigger
Optional sensor
Ignition trigger
Mode and the battery is dis-
®
Mode. This applies to all
®
© 2005 directed electronics, inc.
Mode.
®
Need help?
Do you have a question about the Automate AM1 and is the answer not in the manual?
Questions and answers