Operation; Connecting To A Power Supply - Ryobi RLT-310 Owner's Operating Manual

ATTACHING THE CUTTING HEAD GUARD
WARNING. The line cutting blade on the
grass deflector is sharp. Avoid contact
with the blade. Failure to avoid contact
can result in serious personal injury.
Remove the bag with screws from the grass
deflector.
To fit the cutting head guard, turn the grass trimmer
upside down with the cutting line spool facing you.
Slide the cutting head guard over the spool
assembly and sit it on the mounting boss so that
the large part of the guard sits to the rear. Secure
the guard in place with the screw, Fig.4.
Remove the protective tape from the line cutting
blade, Fig.5.
WARNING. Take care not to cut your
self on the bade. Its extremely sharp.
WARNING. Do not allow familiarity with
products to make you careless.
Remember that a careless fraction of a
second is sufficient to inflict severe
injury.
WARNING. Always wear eye protection
with side shields marked to comply with
ANSI Z87.1. Failure to do so could result
in objects being thrown into your eyes,
resulting in possible serious injury.
WARNING. Never use blades, flailing
devices, wire or rope on this product. Do
not use any attachments or accessories
not recommended by the manufacturer
of this product. The use of attachments
or accessories not recommended can
result in serious personal injury.

CONNECTING TO A POWER SUPPLY

This product is designed with a power cable
retainer that prevents the extension cord from
being pulled loose while using.
ASSEMBLY

OPERATION

Form a loop with the end of the extension cord.
Insert loop portion of extension cord through the
opening in the bottom of the rear handle and place
over power cable retainer, Fig.6.
Slowly pull loop against power cable retainer until
the slack is removed.
Plug product into extension cord.
8
Fig. 4
Fig. 5
Fig. 6