Set Relative Vertical Print Position (Extended) Esc - Epson PX-603F Programming Manual

5.1.23 Set relative vertical print position (extended) ESC (v nL nH m1 m2 m3 m4
ESC (v nL nH m1 m2 m3 m4
[Name]
[Format]
[Range of Definition]
[Function]
[Initial State]
[Related Commands]
Revision: 1
Set relative vertical print position(extended)
1BH, 28H, 76H, nL, nH, m1, m2, m3, m4
nL=04H, nH=00H
0 <= (m4*1000000H +m3*10000H + m2*10H + m1))×1440 <= 1FFFFFFFH
(relative vertical print position value)
1) The printing position in the Y direction is set to positive:
(m4*256*256*256 + m3*256*256 + m2*256 + m1) x (relative vertical print position
value)
from the present Y printing position.
2) If the position set by this command is higher than the top margin position on the current
page, this command is ignored.
3) If the Y direction printing position set by this command extends to a non-printable area,
then the position management coordinate system is set to the next page; and the printing
position in the Y direction is reset to the origin on the Y axis of the new position
management coordinate system.
-
[Setting] Commands whose settings are affected by this command.
None
[Setting] Commands that change the effects of this command.
None
[Operation] Commands whose functionality is affected by this command.
None
[Operation] Commands that change the effects of this command.
The relative vertical position setting value is set by the ESC (U command.
The non-printable area is set by the ESC (c commands.
The relative vertical position setting value, the non-printable area, and the printing position
in the Y direction are reset to their initial states by the ESC @ and ESC (G commands.
Ver 2.00
[Setting]
2011/03/02
Page: 48