Cleaning Time Information; Replace Cartridge Information - Epson PX-603F Programming Manual

7.5 Cleaning time information

Structure
Parameter counter
The parameter <cleaning time information> is two bytes Binary codes that indicate cleaning time or ink filling time.
The unit is second. (This time is total time not passage time or remains time.)
This parameter is added only when status code ST = 07H.

7.6 Replace cartridge information

Structure
Parameter counter
The parameter <change cartridge information> is one byte Binary code that indicates the information about ink cartridge. 00
means that any ink cartridge is changed.
st
Bit0： The 1 data of 0F field
nd
Bit1： The 2 data of 0F field
rd
Bit2： The 3 data of 0F field
th
Bit3： The 4 data of 0F field
th
Bit4： The 5 data of 0F field
th
Bit5： The 6 data of 0F field
If the plural ink cartridges are changed at the same time, the both bits set 1.
Revision: 1
Item Byte (Hex)
Header 1
1
Parameter 2
Item Byte (Hex)
Header 1
1
Parameter 1
Value (Hex)
0C
02
Cleaning time information
Value (Hex)
0E
01
Replace cartridge information
2011/03/02
Page: 81