Selects Dot Size Esc - Epson PX-603F Programming Manual

5.1.20 Selects dot size ESC (e nL nH m d
ESC (e nL nH m d
[Name]
[Format]
[Range of Definition]
[Function]
[Initial State]
[Related Commands]
Revision: 1
Selects dot size
1BH, 28H, 65H, nL, nH, m, d
nL=02H, nH=00H
m=00H, d=00H, 10H, 11H, 12H, 13H
1) The dot size is set according to the value of d.
2) The d parameter has the following meaning:
d=00H: VSD1 1bit (for DOS)
d=10H: Economy 2bit
d=11H: VSD1 2bit
d=12H: VSD2 2bit
d=13H: VSD3 2bit
3) Default dot sizes are specific to each printer model.
4) Dot control is valid irrespective of printing mode or printing density.
5) If the dot size is changed part way through a page, the results are unpredictable.
6) If n has any value other than the above, this command is ignored.
Default
[Setting] Commands whose settings are affected by this command.
Use of the ESC . command requires this command to be sent as follows: ESC ( e 2 0 0 0
[Setting] Commands that change the effects of this command.
Default dot size is automatically selected by the ESC @ or ESC (G commands.
[Operation] Commands whose functionality is affected by this command.
None
[Operation] Commands that change the effects of this command.
None
Ver 1.00
[Setting]
2011/03/02
Page: 45