System Requirements; Package Contents; Mounting Hardware - D-Link DWL-8220AP Install Manual

System Requirements

System Requirements
A Network with a D-Link DWS-1008 Wireless Switch
DWL-8220AP Dualband Access Point
Mounting Bracket
Mounting Template

Mounting Hardware

Rubber Feet
Warning: Installation must be performed by qualified service personnel only.
Please follow all warning notices and instructions marked on the product or
included in the documentation.The manufacturer is not responsible for any radio
or TV interference caused by unauthorized modifications to this equipment.
Such modifications could void the user's authority to operate the equipment.
The DWL-8220AP has two RJ-45 10/100TX ports. The DWL-8220AP receives
power and data through the RJ-45 ports. Use a CAT 5 straight-through
Ethernet cable to connect an DWL-8220AP to a DWS-1008 wireless switch or
other device in the network. The DWL-8220AP supports 802.3af, and also can
receive PoE from D-Link switches and D-Link-approved power injectors.
The two RJ-45 ports support dual-homed configurations for redundancy. A
DWL-8220AP uses only one link for booting, configuration, and data transfer. If
the link becomes unavailable, the AP can reboot using the other link. The ports
are identical except for logical numbering (1 or 2). You can use either port to
connect an access point to a DWS-1008 wireless switch. However, an access
point always attempts to boot on port 1 first. Only if the boot attempt on port
1 fails does the access point attempt to boot on port 2. If one port becomes
unavailable, the other port can provide full power to the access point.
Note: The DWL-8220AP does not support daisy-chain configurations. Do not
connect the access point to another access point.
2

Package Contents

DWL-8220AP Install Guide
D-Link Systems, Inc.