Send Level Control; Fx Loop In/Out - REVV Generator 100 P Owner's Manual

SEND Level Control

4.2
This effects loop has a Send Level control to make sure your effects
volume is optimal. Always make sure to check this knob if you are experi-
encing any overly loud, or quiet effects - or level issues of any kind.
If your effects start clipping - you are driving the loop too hard with this
control.
The master volume controls on the amp also work as return signal con-
trols, so they will need to be adjusted once your send level is set up in
order to drive the power amp to your desired volume.
Note: The level controls on each channel will also affect the send level
being sent from the effects loop - when one is set higher than the rest
you will find your signal changes when using that channel. Be sure to test
each channel & the send level coming from the effects loop. For this
reason it is normally preferable to set the level of your channels first then
adjust your effects loop send level.

FX Loop In/Out

4.3
In order to put the effects loop into the signal path, it needs to be turned
on first (See 4.1). The effects loop, once turned on, can be put in & taken
out of the guitar signal path in a few ways:
Revv Owner's Manual - 23