1. Manuals
  2. Brands
  3. REVV Manuals
  4. Amplifier
  5. D25
  6. Owner's manual

REVV D25 Owner's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Owner's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the D25 and is the answer not in the manual?

Questions and answers

Related Manuals for REVV D25

Summary of Contents for REVV D25

  • Page 1 Owner’s Manual...
  • Page 2 I quickly built a team of people as passionate about guitar as I am, and Revv was born. To be honest, it grew bigger and faster than I had ever hoped...

  • Page 3: Table Of Contents

    R E V V | D 2 5 TABLE OF CONTENTS Warranty & Registration TUBES AND BIAS Safety Instructions & Warnings Set up & Power up Power Tubes Preamp Tubes FRONT PANEL LAYOUT P7/P8 Power Tube Bias Setting The Bias Input Bias Chart Gain Control...

  • Page 4: P4 Warranty & Registration

    This warranty will be honored with original proof of purchase to the original owner only. Warranty work must be authorized by Revv Amplification Inc. in advance. All freight and duty (If applicable) are to be prepaid to and from Revv Amplification Inc. of all products that require and have been approved for warranty work. Revv Amplification Inc.

  • Page 5: P5 Safety Instructions & Warnings

    R E V V | D 2 5 SAFETY & WARNINGS Please read, understand and follow all safety instructions in this manual, as well as those on the rear panel of the amplifier. These instructions and warnings must be followed for your safety, and also to ensure that the amplifier will serve you for many years.
  • Page 6 (down) positions. On the back of the amplifier, and give the tubes at least one minute to warm up. confirm your D25 is safely connected to a load by Now it is time to begin setting all controls while we connecting either the D25 internal speaker cable to wait.

  • Page 7: Input

    Revv footswitch. The Gain Control will add body and drive to your signal. GAIN BOOST SWITCH D25 is capable of a wide variety of tones from crystal clean to quite overdriven. The Gain Boost push button (in) engages a more Note: Experiment with your guitar’s controls, pick attack,...

  • Page 8: Wattage Control Switch

    Output Level down to get a radically different sound out of their D25 when avoid undesirable, harsh digital clipping. recording or sending your signal direct to front of house live, for example.

  • Page 9: Back Panel

    Note: This cable sends important data between the amplifier and the foot switch. If a lesser quality 5 PIN The mains input is a 2-part assembly on the D25; not DIN cable is used, incorrect or erratic behavior could only will it allow you to plug the amplifier power cable occur.

  • Page 10: Xlr Output Connectors

    The cabinet lighting jack on the rear of the amplifier instead. is used to connect the D25 to external Revv speaker Note: The reverb or other effects that the Two-notes cabinets for paired LED lighting operation.

  • Page 11: Power Tubes

    If the bias setting needs performance. to be adjusted or new tubes are installed, the D25’s chassis must be removed from its shell. Remove the top panel on the rear of the amplifier. Remove and set PREAMP TUBES aside chassis screws, then gently pull the amplifier out.

  • Page 12: Speaker Information

    CELESTION VINTAGE 30 CELESTION G12H-75 CREAMBACK The Celestion Vintage 30 features enormously detailed The D25 also comes with a G12H-75 Creamback and complex overtones a warm low-end a famously upgrade driver with a tighter low end than the G12M- rich vocal mid-range and a beautifully detailed top-end.

  • Page 13: Midi

    We recommend starting with PC signals up to 128 programs for program change commands as (virtual cabinet preset recall) for the D25 and then only well as accept Continuous Controller (CC) commands moving on to CC signals for particular and advanced to control functions directly.
  • Page 14 R E V V | D 2 5 Distance A 0-127 0 = 0% ; 63 = 50% ; 127 = 100% Center A 0-127 0 = 0% ; 63 = 50% ; 127 = 100% Position A 0 = Back : 1 = Front Level A 0-107 0 = -95dB ;...

  • Page 15: Torpedo Remote/Load

    XLR jacks and not the The D25 is equipped with a Two-notes reactive load to cabinet itself. The speaker output will always behave allow you to play & record without needing a microphone normally &...

  • Page 16: Foot Controller

    FOOT CONTROLLER & COMPLIANCE CONTROL MODE COMPLIANCE FOR CANADA The D25’s Gain Boost & Reverb may be enabled & This device complies with Industry Canada license- disabled independently via the included 2-button exempt RSS standard(s). Operation is subject to the footswitch.

Table of Contents