Table of Contents
Advertisement
A
3. Close the door until it is at an angle of
approximately 45°.
45°
4. Hold the door trim (B) on the top edge of the
door at the two sides and push inwards to
release the clip seal.
2
B
CAUTION! Rough handling of the
glass, especially around the edges of
the front panel, can cause the glass to
break.
5. Pull the door trim to the front to remove it.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
16
A
1
6. Hold the door glass panels on their top edge
one by one and pull them up out of the guide.
7. Clean the glass panel with water and soap. Dry
the glass panel carefully.
When the cleaning is completed, do the above
steps in the opposite sequence. Install the smaller
panel first, then the larger and the door.
WARNING! Make sure that the
glasses are inserted in the correct
position otherwise the surface of the
door may overheat.
REPLACING THE LAMP
WARNING! Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
The back lamp
The lamp glass cover is at the back of
the cavity.
1. Turn the lamp glass cover counterclockwise to
remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a suitable 300 °C
heat-resistant oven lamp.
Use the same oven lamp type.
4. Install the glass cover.
Hide quick links:
Advertisement
Table of Contents
