Skytech SKY MRCK SR1001-1 Installation And Operating Instructions Manual

IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO NOT

INTRODUCTION

This remote control system was developed to provide a safe, reliable, and user-friendly remote control system for gas heating
appliances. The system is operated manually from the transmitter. The system operates on radio frequencies (RF) within a 20-foot
range using non-directional signals. The system operates on one of 255 security codes that are programmed into the transmitter at the
factory; the remote receiver must learn the transmitter code prior to initial use.

TRANSMITTER

f i r e - p a r t s . c o m
SIGNAL
LIGHT
ON/HI
ON/OFF
LO/OFF
BUTTONS
FRONT
POWER SETTING – SR 1001-1
The electronics in the remote control system have the capability of "powering"
two different types of DC-powered components. If any operational problems are
noted contact Skytech Systems, Inc.
The RECEIVER comes from the factory programmed to provide continuous DC
voltage (4.5 VDC to 6.0 VDC) to a servomotor

REMOTE RECEIVER

The remote receiver (right) operates on four 1.5V AA-size batteries. It is
recommended that ALKALINE batteries be used for longer battery life and
SKYTECH SR1001-1 (SKY MRCK)
Model: SR1001-1
INSTALLATION AND OPERATING INSTRUCTIONS
SINGLE-FUNCTION WIRELESS REMOTE CONTROL SYSTEM
FOR OPERATING HI/LOW SERVO MOTOR
ATTEMPT TO INSTALL OR OPERATE
This remote control SYSTEM offers the user a battery-operated remote control to
power a DC servo motor such as those used with gas valves used in some
decorative gas logs, gas fireplaces and other gas heating appliances.
WALL CLIP
SLOT
The servo motor circuit uses the battery power from the receiver to operate a
servomotor. The circuit has reversing polarity software, which reverses the
positive (+) and negative (-) output of the receiver's battery power to drive the
servo motor forward/backward (HI/LO FLAME). The SYSTEM is controlled by the
remote transmitter.
The transmitter operates on a 12V battery (A-23). Before using the transmitter
install the 12-volt battery in the battery compartment.
It is recommended that ALKALINE batteries always be used for longer battery life
and maximum operational performance.
12V
BATTERY
The transmitter has ON/HI and LO/OFF functions that are activated by pressing
COMPARTMENT
either button on the face of the transmitter. When a button on the transmitter is
pressed, a signal light on the transmitter illuminates to verify that a signal is being
sent. Upon initial use, there may be a delay of three seconds before the remote
receiver will respond to the transmitter. This is part of the system's design. If the
BACK
signal light does not illuminate, check the position of the transmitter's battery.
IMPORTANT
(SKY MRCK)
REV. 4/14/11 Page 1 of 4