Connecting The Dp-301P+ To Your; Network - D-Link DP-301P+ Quick Installation Manual

Connecting The DP-301P+ To Your

Network

First, insert one end of a straight-through CAT5 Ethernet RJ-45 cable
into the "Network Port" (shown below.) Connect the other end of the
cable to the LAN port of the router or
the power cord to the DP-301P+ until you are advised to do
so.
Next, make sure that the Printer is turned OFF.
Connect the parrallel end of the DP-301P+ to the parallel port of the
printer
Turn ON the printer.
Network Port
Then, plug one end of the power adapter into the DP-301P+ and the
other end into your electric outlet. The DP-301P+ will turn on and
begin a self-test.
switch. Note: Do not connect
2
Receptor for AC
Power Adapter