Setting Up The Dp-301U; Installing The Print Server - D-Link DP-301U Manual

Setting up the DP-301U

Installing the Print Server

WARNING: Configuration problems may result if the Print Server is powered up
without first establishing its network connection.
Follow this procedure to avoid complications at the configuration stage.
1. Confirm proper operation of the printers to be connected to the DP-301U.
2. When you have confirmed proper operation of the printer, switch its power OFF.
3. Confirm that your network is operating normally.
4. Connect the DP-301U RJ-45 Connector to the network, using an Ethernet CAT5
cable.
5. While the printer is powered OFF, install the DP-301U USB port connector into the
USB port on the network printer.
6. Switch on the connected printer.
7. Plug the AC power adapter's DC output plug into the DC 5V power socket on the
rear panel of the Print Server.
8. Plug the power adapter into a power outlet. This will supply power to the Print
Server, as it has no external power switch. The green Power LED on the Print
Server's front panel should illuminate steadily, and the Print Server's Self-Test will
proceed.
6