Setting Up The Dp-101P - D-Link DP-101P+ User Manual

Printer Port
The printer port, is configurable by commands in the PS Admin program, or by commands issued to the DP-
101P+ via Telnet. See the PS Admin User's Guide for configuration procedures.
The print server also supports web configuration permitting users to configure settings through the web
browser. DP-101P+ default IP address as follows:
•
Default IP address – 192.168.0.10
•
Subnet Mask – 255.255.255.0
Note:
The PC's IP address must be in the same network with the print server's IP address for the two
devices to communicate.
3. 3. 3. 3.

Setting up the DP-101P+

Setting up the DP-101P+ Setting up the DP-101P+
3. Setting up the DP-101P+ Setting up the DP-101P+
Note: the network connection should be made before supplying power to the DP-101P+.
1. Confirm proper operation of the printer to be connected to the DP-101P+.
2. When you have confirmed proper operation of the printer, switch its power off.
3. Confirm that your network is operating normally.
4. Connect the DP-101P+ to the network (through the RJ-45 receptacle on the print server's rear end).
WARNING: Configuration problems may result if the DP-101P+ is powered up without first establishing its network
connection. Follow this procedure to avoid complications at the configuration stage.
5. While the printer is powered off, connect the DP-101P+ print server directly to the printer parallel
port.
6. Switch printer power on.
7. Plug the AC Power adapter's output plug into the DC power input socket on the rear end of the
DP-101P+.
8. Plug the AC Power adapter into an electric service outlet. This will supply power to the DP-
101P+. (The DP-101P+ has no power switch.) The DP-101P+'s self-test routines will proceed
automatically.
7