Assemble - McGREGOR MET2523 Original Instruction Manual

Assemble

Assembling instructions
Always take care when removing the packaging to prevent damage to you or to the grass trimmer.
IMPORTANT! Before assembling the grass trimmer, check all the parts indicated in the manual
are in the box. Inspect all the parts for signs of damage. Do not assemble the grass trimmer if you
observe any damaged components.
NOTE: Before using the tool, read the instruction book carefully.
INTENDED USE
The machine is intended for cutting weed, grass or similar soft vegetation in areas that are hard to
reach, e.g. under bushes, on slopes and edges. It may not be used to work on unusual thick, dry or
wet grass, e.g. pasture grass, or to shred leaves.
This machine is intended for private domestic use only, not for any commercial trade use. It must
not be used for any purposes other than those described.
1. ASSEMBLY OF GRASS TRIMMER (SEE FIG A, B, C1, C2)
1) Insert the telescopic shaft into the lower tube firmly until a "click" is heard. (See Fig. A)
2) Insert the upper tube into telescopic shaft firmly until a "click" is heard. (See Fig. B)
3) Make sure the locking knob (a) is tightened to fix the machine. (See Fig. C1, C2)
NOTE: The holes should be on the same side.
A
C1
a
Customer helpline 0345 605 2065
B
a
C2
9