McGREGOR MET2523 Original Instruction Manual page 14

Operate
Operating instructions
5. WHEN REFITTING THE SPOOL CAP
Keep all areas of the cap and spool holder clean.
Refit the cap, pressing firmly down towards the spool holder to ensure cap is fully located.
Check that the cap is correctly fitted by trying to remove it without depressing the two latches.
6. TO REPLACE CUT LINE
For your convenience it is recommended you buy spool and line complete.
-- TO FIT SPOOL AND LINE COMPLETE:
1) Remove old spool.
2) Place new spool into cutting head. Release one line from cleat and feed line through eyelet.
3) Repeat for second line.
4) Refit the cap.
-- TO FIT NYLON LINE ONLY:
WARNING!
IMPORTANT - ALWAYS WIND THE LINE ONTO THE UPPER SECTION OF THE SPOOL FIRST.
1) Take a line of approximately 3m (Fig. L1).
2) Insert 15mm of line into the hole in the spool and wind line in the direction of the arrows on the top of
the spool (Fig. L2).
3) Leave approximately 100mm of line unwound and place into cleat (Fig. L3).
4) Then fit spool as described in "TO FIT SPOOL AND LINE COMPLETE".
Care should be taken to ensure that the line is neatly coiled on the spool. Failure to do so will impair the
efficiency of the automatic line feed.
L1
L3
14
Your trimmer is designed to use only line with a maximum diameter of 1.65 mm.
3m
Customer helpline 0345 605 2065
L2