Connecting The Keen Unit - Electric Mirror INTEGRITY Installation Instructions Manual

CONNECTING THE KEEN UNIT

The Keen unit is pre-installed on the mirror at our
factory. We suggest not removing the circuit board
component..
There are 4 total connections on the Keen unit.
1. 12V Power input. 5.5 mm x 2.1 mm pin DC Plug
2. 12V Switching Output. 2-pin JST Connector
3. 12V Additional Nightlight Output. 2-pin JST
Connector
4. 0-10V Dimming Output. 2-pin JST Connector
There may be a grounding tab to assist with the touch
capacitance of the unit. Do not remove or alter this tab
or the touch elements.
Keen is powered from a 12V power source included in
the lighted unit. Connect the DC jack into the port on
the Keen unit.
There are up to three sets of output wiring coming from
the unit. The version of Keen you have selected will
indicate what sets of wiring will provided exiting the
unit. These sets should be color coordinated to assist
with final assembly.
For each version of Keen, there will be the Gray and
Violet wiring set. This set controls the 0-10V dimming
portion of the Keen. The connectors coming off of the
Keen unit (on mirror) will mate with the connectors
coming from the chassis. Plug these connectors in until
you hear a click noise, this will indicate proper
connection.
In versions K2 and K3 of the Keen product, there will
be an extra set of connector wiring included in the unit.
This will control an internal relay switching the power to
the Ballast/Driver on or off. Plug these connectors in
until you hear an audible click..
*See item below about Fluorescent Lamp Seasoning*
4