Operating instructions
Power Supply connections
Camera can work with either 24VAC or 12VDC, dual voltage power. Primary and
secondary grounds are completely isolated to avoid the possible ground-loop
problems.
Using OSD controller
Setup menu can be accessed and controlled by OSD control joystick on the rear
of the camera unit. Five commands are available with the joystick.
OSD Control Joy Stick
HD-SDI or EX-SDI is selectable by Video format switch only.
i
TVI mode or AHD mode is selectable in the menu only. (SYSTEM> ANALOG MODE)
Description of the OSD control operation
1. SET (
) : Access to the menu or enter the setting. To enter the main menu,
●
press the Set Key down.
2. UP/DOWN (▲/▼) : Choose the desired sub-menu and to move the cursor up
or down.
3. LEFT/RIGHT (◄/►) : Set up the value of the selected menu. Used to adjust the
desired menu selection and to move the cursor left or right.
4. '
' denotes the long press down straightly for about 2 seconds
Description of the Motorized ZOOM&FOCUS adjustment
i
Works only when OSD Menu is inactive.
1. ▲ : Zoom In
2. ▼ : Zoom Out
Video format Switch
CONTROL
HD-ANALOG
EX-SDI
HD-SDI
POWER
3. ◄ : Focus Near
4. ► : Focus Far
EN
7