Table of Contents
Advertisement
MAINTENANCE & ADJUSTMENTS
H. Adjust Carriage for (optional) Emergency Release System
The carriage on this opener can be adjusted to work with the Emergency
Release Cable Lock System (available at your local Genie® Retailer).
1.
Operate door to mid position.
2.
Pull emergency release cord and manually close door.
3.
Make sure carriage latch is in the upright (engaged)
position.
4.
Remove (2) 5/16" machine screws and cap.
5.
Pull spring assembly out and reverse direction.
6.
Install cap and machine screws.
Emergency Release cable can now be assembled to the
carriage assembly.
I. Adjustment Guides
WARNING
!
TO AVOID INJURY OR DAMAGE
•
NEVER adjust the force settings to adjust for damage,
including an unbalanced door, binding door track or
broken spring.
•
Perform a CONTACT REVERSE TEST monthly. See page 10.
Force Settings
Force settings are pre-programmed at the factory and applied
during the Open/Closed Limit settings steps (see page 8). For
normal use, these settings should not need adjustments with this unit.
Conditions possibly requiring adjustments are:
1. Doors with very sti weather seals.
2. Doors that start down, STOP, and reverse before closing.
3. Doors that start up, but STOP before they completely open.
Press and hold both up and
down arrow buttons until
round LED turns RED, release
button. BLUE LED will ash 3
times.
LEDs will now display current UP force setting (See chart).
Press either arrow button until
desired UP force setting is
reached (see chart).
Once setting is chosen, press
and release. This will lock the
UP force setting.
LEDs will now show current DOWN force setting. (See Chart).
Press either arrow button until
desired DOWN force setting is
reached. (See chart).
Once setting is chosen, press
and release. This will lock the
DOWN force setting.
The LEDs will now turn BLUE then o . This con rms
that both force setting have been reset and unit is
ready for normal operation.
Repeat "Learn Force Limits and Contact Reverse Test" page 10
J. Resetting Travel Limits
See pages 8-9 to reset travel limits. Force setting and contact reverse test must be performed in the event of a travel limit change.
Pour éviter les blessures ou des dommages
•
NE JAMAIS régler la force pour compenser des dommages,
y compris une porte mal équilibrée, un rail de porte coinçant
ou des ressorts cassés.
•
Tous les mois, EFFECTUEZ LE TEST D'INVERSION AU CONTACT.
Voir page 10.
RED
OFF
BLUE
OFF Flashes
3 Times
See Chart
See Chart
OFF
BLUE
BLUE
Rail, Chain, & Door
Arms not shown for
clarity
DOOR
AVERTISSEMENT
!
15
Hide quick links:
Advertisement
Table of Contents
