Table of Contents
Advertisement
8
REMOTE CONTROL
1. Battery replacement.
• To open, gently push straight out on battery
cover lock tab as shown. (Fig. 8-1).
• Slide open battery cover.
– Remove old battery.
• Make sure new battery is facing proper direction
(Match battery polarity with symbols inside
battery housing) (Fig. 8-2).
– Recommended replacement battery type:
Alkaline A23, 12 volt.
NOTE: Batteries differ in care and maintenance.
Follow the manufacturer's directions for battery
maintenance, replacement, and use.
• Slip new battery into place.
– Slide battery cover until it clicks shut.
• Operate remote to make sure it is working
properly. (No re-programming is needed.)
2. Visor clip.
(The visor clip may come already installed.)You
will have to install the visor clip if you choose to
attach your remote to the car visor.
• Slide visor clip into back of remote control.
– It will snap into place (Fig. 8-3).
FIG. 8-3
Attach visor clip.
9
LIGHT BULB / LENS INSTALLATION
For added safety and protection please unplug
opener before installing light bulb.
NOTE: For lens covers locate Box 4.
1. Light bulb.
• Recommendations.
– Do NOT use a short neck bulb.
– Light bulbs should be no more than 60 Watts.
– Use a heavy duty service bulb for longer life.
• Screw 1 bulb into each socket.
2. Lens.
• Select a white (lamp) cover.
• On the power head end nearest the garage
door, line up lamp lens tabs on power head with
corresponding slots in lens (Fig. 9-1).
• Slide lens onto power head. Make sure the tabs
are fully engaged into lens slots (Fig. 9-2).
• Repeat for rear lens on power head.
• Plug power cord back into electrical outlet.
• Test lamp operation.
24
BATTERY REPLACEMENT AND VISOR CLIP INSTALLATION
WARNING
PN# 37026500123
Slide out
FIG. 8-1 Open battery cover.
FIG. 8-2 Match battery polarity.
Lens tabs
Light bulb socket
FIG. 9-1
Slide each lens onto motor cover.
FIG. 9-2
Fasten lens.
02/26/2010 REV. 1
– and + polarity marks
Light bulb socket
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
