Section 17.Port Monitor Commands; Port Monitor - D-Link xStack DXS-3250 Cli Manual

D-Link CLI Reference Guide
Section 17. Port Monitor Commands

port monitor

The port monitor Interface Configuration mode command starts a port monitoring session. To stop a port
monitoring session, use the no form of this command.
Syntax
port monitor src-interface [rx | tx]
no port monitor src-interface
Parameters
•
src-interface—Valid Ethernet port. (Full syntax: unit/port)
•
rx—Monitors received packets only.
•
tx—Monitors transmitted packets only.
Default Configuration
Monitors both received and transmitted packets.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command enables traffic on one port to be copied to another port, or between the source port (src-interface)
and a destination port (port being configured).
The following restrictions apply to ports configured as destination ports:
The port cannot be already configured as a source port.
The port cannot be a member in a port-channel.
An IP interface is not configured on the port.
GVRP is not enabled on the port.
The port is not a member of a VLAN, except for the default VLAN (will automatically be removed from the default
VLAN).
The following restrictions apply to ports configured to be source ports:
The port cannot be already configured as a destination port.
Example
The following example copies traffic on port 1/7 (source port) to port 1/1 (destination port).
Console(config)# interface ethernet 1/1
Console(config-if)# port monitor 1/7
Page 204