Table of Contents
Advertisement
The IGMP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
config igmp
show igmp
show igmp group
Each command is listed, in detail, in the following sections.
config igmp
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To configure the IGMP for the IP interface System.
DGS-3312SR Layer 3 Gigabit Switch
Parameters
[ipif <ipif_name 12> | all] {version <value 1-2> | query_interval
<sec 1-65535> max_response_time <sec 1-25> |
robustness_variable <value 1-255> |
last_member_query_interval <sec 1-25> | state [enable | disable]
{ipif <ipif_name 12>}
{group <group>} {ipif <ipif_name 12>}
Used to configure IGMP on the switch.
config igmp [ipif <ipif_name 12> | all] {version <value 1-2> |
{query_interval <sec 1-65535> | max_response_time <sec 1-
25> | robustness_variable <value 1-255> |
last_member_query_interval <sec 1-25> | state [enable |
disable]
This command allows you to configure IGMP on the switch.
<ipif_name 12> − The name of the IP interface for which to
configure IGMP.
all − Specifies all the IP interfaces on the switch.
version <value 1-2> − The IGMP version number.
query_interval <sec 1-25> − The time in seconds between
general query transmissions, in seconds.
max_response_time <sec 1-25> − Enter the maximum time in
seconds that the switch will wait for reports from members.
robustness_variable <value 1-255> − This value states the
permitted packet loss that guarantees IGMP.
last_member_query_interval <value 1-25> − The Max Response
Time inserted into Group-Specific Queries sent in response to
Leave Group messages, and is also the amount of time between
Group-Specific Query messages. The default is 1 second
state [enable | disable] − Enables or disables IGMP for the
specified IP interface.
Only administrator-level users can issue this command.
122
18
IGMP C
OMMANDS
Advertisement
Table of Contents
