Table of Contents
Advertisement
enable ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the ipif function on the switch:
create ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create an IP interface on the switch:
DGS-3312SR Layer 3 Gigabit Switch
Used to enable an IP interface on the switch.
enable ipif {<ipif_name 12> | all}
This command will enable the IP interface function on the switch.
<ipif_name 12> − The name for the IP interface to be created. This
name cannot exceed 12 characters.
all – Entering this parameter will enable the IP interfaces currently
configured with this command.
None.
DGS-3312SR:4#enable ipif s2
Command: enable ipif s2
Success.
DGS-3312SR:4#
Used to create an IP interface on the switch.
create ipif <ipif_name12> <network_address> <vlan_name
32> {state [enable | disable]} {secondary | {state [enable |
disable]}
This command will create an IP interface.
<ipif_name 12> − The name for the IP interface to be created. The
user may enter an alphanumeric string of up to 12 characters to
define the IP interface.
<network_address> − IP address and netmask of the IP interface
to be created. The address and mask information can be specified
using the traditional format (for example, 10.1.2.3/255.0.0.0 or in
CIDR format, 10.1.2.3/8).
<vlan_name 32> − The name of the VLAN that will be associated
with the above IP interface.
secondary – Enter this parameter if this configured IP interface is
to be a secondary IP interface of the VLAN previously specified.
secondary interfaces can only be configured if a primary interface
is first configured.
state [enable | disable] − Allows you to enable or disable the IP
interface.
Only administrator-level users can issue this command.
118
Advertisement
Table of Contents
