Table of Contents
Advertisement
The DGS-3312SR implements the server-side of the IEEE 802.1x Port-based Network Access Control. This mechanism is
intended to allow only authorized users, or other network devices, access to network resources by establishing criteria for each
port on the switch that a user or network device must meet before allowing that port to forward or receive frames.
The 802.1X commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
enable 802.1x
disable 802.1x
show 802.1x auth_state
show 802.1x
auth_configuration
config 802.1x auth_mode
config 802.1x capability
config 802.1x auth_parameter
ports
config 802.1x init
config 802.1x reauth
config radius add
config radius delete
config radius
show radius
Each command is listed, in detail, in the following sections.
DGS-3312SR Layer 3 Gigabit Switch
Parameters
ports [<portlist>]
ports [<portlist>]
[port_based | mac_based]
[ports <portlist> | all] [authenticator | none]
[<portlist> | all] [default | {direction [both | in] | port_control
[force_unauth | auto | force_auth] | quiet_period <sec 0-
65535> | tx_period <sec 1-65535> | supp_timeout <sec 1-
65535> | server_timeout <sec 1-65535> | max_req <value
1-10> | reauth_period <sec 1-65535> | enable_reauth
[enable | disable]}]
{port_based ports [<portlist> | all]} | mac_based [ports]
[<portlist> | all] {mac_address <macaddr>}]
{port_based ports [<portlist> | all]} [<portlist> | all]
{mac_address <macaddr>}]
<server_index 1-3> <server_ip> key <passwd 32> [default
{auth_port <udp_port_number 1-65535> | acct_port
<udp_port_number 1-65535>}]
<server_index 1-3>
<server_index 1-3> {ipaddress <server_ip> | key <passwd
32> [auth_port <udp_port_number 1-65535> acct_port
<udp_port_number 1-65535>]}
NOTE: As a stand-alone switch or as a master switch in a switch stack,
the switch number will be referred to as 15 for all configurations, graphs
and tables.
802.1X C
174
24
OMMANDS
Advertisement
Table of Contents
