Ip Addresses And Snmp Community Names - D-Link DGS-3308FG User Manual

8-port Gigabit Ethernet Switch User's Guide
Data width:
Parity:
Stop bits:
Flow Control
Make sure the terminal or PC you are using to make this connection is configured to match these settings.
If you are having problems making this connection on a PC, make sure the emulation is set to VT-100. If you still don't
see anything, try hitting <Ctrl> + r to refresh the screen.

IP Addresses and SNMP Community Names

Each Switch must be assigned its own IP Address, which is used for communication with an SNMP network manager or
other TCP/IP application (for example BOOTP, TFTP). The Switch's default IP address is 10.90.90.90. You can change the
default Switch IP Address to meet the specification of your networking address scheme.
The Switch is also assigned a unique MAC address by the factory. This MAC address cannot be changed, and can be found
from the initial boot console screen – shown below.
The Switch's MAC address can also be found from the console program under the Switch Information menu item, as
shown below.
8 bits
none
1
None
Figure 5-1. Boot screen
15