Installing The Vanishing Edge; Tm Strainer; Installing The Bottom Grid - Westinghouse QK042 Owner's Manual

Installation (continued)

INSTALLING THE VANISHING EDGE

NOTE:
If you are installing a garbage disposer (not supplied), do not install the strainer
assembly. You will need to purchase a special adaptor that will replace the flange
from your garbage disposer. The flange adaptor is available from the manufacturer.
Install the garbage disposer according to the manufacturer's installation
instructions replacing the flange for the adaptor.
- Apply a small amount of plumbers putty (not included) in the notch
around the drain hole of the sink (A) .
- Connect the upper strainer body (3) and the strainer ring (4), and insert
them into the drain hole from the top of the sink (A) .
- Connect the strainer gasket (5) and lower strainer body (6), and insert
them into the drain hole from underneath the sink (A) .
- Insert the strainer screw (2) through the entire assembly, from the
upper strainer body (3) to the lower strainer body (6) . Tighten with a
flathead screwdriver.
- Connect the plastic flange (7) and the tail pipe (8), and thread the
connecting nut (9) through the tail pipe and flange up to the lower
strainer body (6) . Tighten the connecting nut by hand .
NOTE:
The plastic flange (7), tail pipe (8), and connecting nut (9) are not supplied.

INSTALLING THE BOTTOM GRID

- Ensure that the vanishing edge
(A) before placing the bottom grid (B) .
- The bottom grid (B) must be positioned with the rubber supports down .
Tilt the grid up so it is at a slight angle, slide it into the sink (A), and place
it so that it is sitting flat on the bottom of the sink.
TM STRAINER
TM strainer basket (C) is already in the sink
Please contact cs@conglomkb .com or 1-877-333-0098 for further assistance .
A
A
11
1
2
3
4
5
6
7
8
Not supplied
9
B
C
B
CONGLOMKB .COM