H2oLabs 300F Instruction Manual page 9

3. Wash the Boiling Chamber using a couple drops of dish soap and a
little warm water. Swab the interior of the Boiling Chamber with a
regular soft sponge and then rinse and dry well. Never use abrasive
detergent cleaners, metal brushes or metal scouring pads. And to protect
the electrical components, never submerge the Main Body or Head
Assembly in water.
When using the appliance for the first time, it is possible that some
harmless material may remain from manufacturing, packaging or
shipping. This could leave an unwanted taste or scent in the purified
water. For this reason it is not recommended that water from the first
cycle be consumed. However it may be used to rinse the Activated
Carbon Pod to use for the second cycle, or for pets, watering plants, for
steam irons or in humidifiers, etc. or may be discarded. (Do not use the
st
Activated Carbon Pod during the 1 cycle.)
OPERATING INSTRUCTIONS
Follow these simple steps to ensure that you maintain a continuous
supply of drinking water. It only takes a couple minutes to prepare the
unit to begin the distillation process.
Do not plug in to household electrical outlet until the unit is full,
outside is dry and unit is completely assembled.
1. Using a pitcher or directly from your sink faucet/sprayer hose, fill the
Boiling Chamber with tap water up to the internal fill line, (approx. 2
inches, (2.5 cm), from the top. Note: When filling, do not let the water
run unattended to prevent spillover which could allow water to get in to
the electrical components at the base of the unit.
2. Position unit on dry countertop and dry off any moisture on the
exterior of the unit. While all cords are unplugged, also make sure the
plugs and sockets are dry.
3. Position and seat the Head Assembly onto the Main Body while
lining up the Fan Cord with the Fan Cord Socket. Insert the Fan Cord
Plug into the Fan Cord Socket firmly until it has completely seated.
IMPT: Push Fan Cord plug in with force so white line is not visible.
- 9 -