H2oLabs 300F Instruction Manual page 14

The Activated Carbon Pod helps to reduce any
noticeable taste or residual gases. Replace the
Activated Carbon Pod every 30 to 60 days, or
whenever there is any noticeable taste or odor.
To replace the Pod, press the middle tabs on
each side of the nozzle and TILT it out of the
slots. (See illustration.) Use force if necessary.
Press the tabs carefully to prevent breaking the Glass Insert. (Should
the Glass Insert break, replacements are available. However it is
perfectly acceptable to continue using the distiller without the Glass
Insert as the Nozzle is made from food-grade, safe material.)
It may be helpful to use small flat head screwdriver to push the Nozzle
tabs in to release them from the slots. If using a screwdriver, be careful
not to enlarge or damage the slots.
It is normally not necessary to clean the Glass Insert until changing the
Activated Carbon Pod. When necessary to remove it, take care to
prevent breakage. Gently press top of Nozzle and insert a small flat-
tipped screw driver under the release tab to slide the Glass Insert out.
TIPS
As mentioned previously, Run your system at night - Prepare the unit
at any convenient time during the day. But wait until before retiring
each night to turn it on. That way, any noticeable noise or heat from the
process will be minimized. More importantly, the unit will have ample
time to cool down by morning which will make it quicker, easier and
safer to clean and prepare for the next cycle. Plus you'll have a fresh
and full 4 Litres first thing in the morning to enjoy all day.
- 14 -