H2oLabs 300F Instruction Manual page 6

4. Place a towel or soft cloth on the work surface to protect the glass
Carafe. There are two indentations on the Carafe body. Wrap one strap
around the Carafe, placing it in the indentation. Position the strap so
that the cap nut is facing towards the Carafe. Snap the other end with
screw slot over the cap nut. (See above.) Do the same for the other
strap. The cap nut orientation must be the same for both straps.
that it holds but do not tighten yet. Move
the Handle to the right a little so that the
black reference line is just covered evenly
and straight by the Handle edge.
5. Align right-hand side of the screw slots to the
black reference line on the Carafe label.
6. Fit the handle over
the two screw slots.
Align the Handle
with the slots and the
black reference line
to the right.
7. Insert the upper screw first. Using a
Phillips, (cross-head), screwdriver, turn the
screw so that it holds, but do not tighten all
the way yet.
8. Insert the
lower screw
next and turn so
- 6 -