AEG BPE842720M User Manual page 36

36 www.aeg.com
11.2 Removing the shelf
supports
To clean the oven, remove the shelf
supports.
CAUTION!
Be careful when you remove
the shelf supports.
1. Loosen the screw. Pull the front of
the shelf support away from the side
wall.
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
1
Install the removed accessories in the
opposite sequence.
11.3 Pyrolytic cleaning
CAUTION!
Remove all accessories
except for the shelf supports
and telescopic runners.
The pyrolytic cleaning
procedure cannot start:
• if you did not remove the core
temperature sensor plug from the
socket.
• if you did not fully close the oven
door.
Remove the worst dirt manually.
2
CAUTION!
If there are other appliances
installed in the same
cabinet, do not use them at
the same time as the
function: Pyrolytic Cleaning.
It can cause damage to the
appliance.
1. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
2. Turn on the oven.
3. Select the Menu and press the rotary
knob to confirm.
4. Select Pyrolytic Cleaning and press
the rotary knob to confirm.
5. Select the duration of the cleaning
procedure:
Option
Quick
Normal
Intense
6. Press the rotary knob to confirm.
When the pyrolytic cleaning
starts, the oven door is
locked and the lamp does
not work. The cooling fan
works at a higher speed.
To stop the pyrolytic
cleaning before it is
completed, turn off the
oven.
WARNING!
After the function is
completed, the oven is very
hot. Let it cool down. There
is a risk of burns.
When the function ends, the
door stays locked for the
cool down phase. Some of
the oven functions are not
available.
Description
1 h for a low
degree of dirt
1 h 30 min for
a usual de-
gree of dirt
3 h for a high
degree of dirt