Installation - AEG BEE255632M User Manual

Problem
The water comes out of the
cavity embossment.
The appliance is activated
and does not heat up. The
fan does not operate. The
display shows "Demo".
11.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

12. INSTALLATION

WARNING!
Refer to Safety chapters.
Possible cause
There is too much water in
the cavity embossment.
The demo mode is activa-
ted.
on the front frame of the appliance
cavity. Do not remove the rating plate
from the appliance cavity.
.........................................
.........................................
.........................................
ENGLISH
Remedy
Deactivate the oven and
make sure that the appliance
is cold. Wipe the water with
a cloth or sponge. Add the
correct amount of water to
the cavity embossment. Re-
fer to the specific procedure.
1. Deactivate the oven.
2. Press and hold at the
same time
.
3. The first digit on the dis-
play and Demo indicator
start to blink.
4. Enter the code 2468 by
turning the knob for the
temperature right or left
to change the values
and press to confirm.
5. The next digit starts to
blink.
6. Demo mode deactivates
when you confirm the
last digit and the code is
correct.
35