TP-Link TL-WR940N User Manual page 51

Chapter 4
2. Enter the following
• Destination Network
or host that you want to assign to a static route.
• Subnet Mask
the network portion, and which portion is the host portion.
• Default Gateway
allows for the contact between the router and the network or host.
3. Select Enabled or
4. Click Save.
You can also do the following operations to modify the current settings.
• Click Delete to delete the entry.
• Click Enable All to enable all the entries.
• Click Disable All to disable all the entries.
• Click Delete All to delete all the entries.
• Click Previous to view the information on the previous screen and
information on the next screen.
4. 10. 2. System Routing Table
1. Visit http://tplinkwifi.net, and log in with the username and password you set for
the router.
2. Go to Advanced Routing
route entries in use.
information.
- The Destination Network is the address of the network
- The Subnet Mask determines which portion of an IP Address is
- This is the IP Address of the default gateway device that
Disabled for this entry on the
> System Routing
Status drop-down list.
Table, and you can view all the valid
Configure
Next to view the
49