Kenwood DNX8170DABS Instruction Manual page 79

Ñ
Removing the unit
1) Remove the trim plate by referring to step 1 in
"Removing the trim plate".
2) Insert the two extraction key (accessory 5)
deeply into the slots on each side, as shown.
3) Lower the extraction key toward the bottom,
and pull out the unit halfway while pressing
towards the inside.
NOTE
• Be careful to avoid injury from the catch pins on
the extraction key.
4) Pull the unit all the way out with your hands,
being careful not to drop it.
Ñ
3 way speaker system setup
(
5
When connecting to an external amplifier,
connect its ground wire to the car's chassis to
avoid damaging the unit.
Preout
RCA Cable
(Sold separately)
NOTE
• For speaker system setup, see 3 way speaker
system setup (P.70).
• For speaker setup and crossover setup, see
Controlling Audio (P.68).
• For how to connect speaker wires to terminals
other than speaker terminals and Preout
terminals, see Connecting the system and
external components (P.81) and Connecting
wires to terminals (P.80).
Connection/Installation
Subwoofer Preout
Mid Range Preout
Tweeter Preout
Power amplifier
(optional
accessory)
Input
White
+
To mid range left
speaker
White/Black
Gray
+
To mid range right
speaker
Gray/Black
Green
+
To tweeter left speaker
Green/Black
Purple
+ To tweeter right
speaker
Purple/Black
Speaker impedance: 4-8 Ω
)
Speaker
79
English