Kenwood DNX8170DABS Instruction Manual page 70

Controlling Audio
3
Set each item as follows.
HPF FREQ
High Pass Filter adjustment. (When front or
rear speaker is selected on Speaker Select
screen)
LPF FREQ
Low Pass Filter adjustment. (When subwoofer
is selected on Speaker Select screen)
Slope*
1
Sets a crossover slope.
Gain
Adjusts the front speaker, rear speaker, or
subwoofer level.
TW (Tweeter) Gain *
Adjusts the tweeter level. (When front is
selected on Speaker Select screen)
Phase Inversion*
Sets the phase of subwoofer output.
Check [Phase Inversion] to shift the phase
180 degrees. (When subwoofer is selected
on Speaker Select screen)
* Only when "LPF FREQ"/"HPF FREQ" is set to
1
a mode other than "Through" in [Xʼover].
* Only when "Tweeter" is set to "Small",
2
"Medium", "Large" in [Speaker Setup].
* 3 Only when "Subwoofer" is set to a mode
other than "None" in [Speaker Setup].
When Speaker network is set to 3 way:
70
2
3
FREQ (High Pass)
High Pass Filter adjustment. (When tweeter is
selected on Speaker Select screen)
HPF FREQ, LPF FREQ (Band Pass)
Band Pass Filter adjustment. (When mid
range speaker is selected on Speaker Select
screen)
FREQ (Low Pass)
Low Pass Filter adjustment. (When woofer is
selected on Speaker Select screen)
Slope*
1
Sets a crossover slope.
Gain
Sets gain of each speaker.
Phase Inversion*
Sets the phase of tweeter, mid range, and
woofer output.
Check [Phase Inversion] to shift the phase
180 degrees.
NOTE
• For how to switch to the 3-way speaker system,
see 3 way speaker system setup (P.70).
Connecting 3-way speakers with the 2-way mode
selected can break the speakers.
Ñ
3 way speaker system setup
(
Select the appropriate crossover network
mode according to the speaker system (2-way
speaker system or 3-way speaker system).
1
Press the [HOME] button.
HOME screen appears.
2
Touch [
].
Source selection screen appears.
3
Touch [STANDBY].
4
Press the [G] button and the [NAV] button
for 1 second at the same time.
Speaker system select screen appears.
3
)