Example 1: Single-Parameter Setting By Scanning 1D Barcodes - Mindeo FS390 User Manual

6-2 Example 1: Single-parameter setting by scanning 1D barcodes

Important notes:
1. After each successful programming, the scanner will beep twice.
2. Throughout the programming barcode menus, the factory default settings are indicated with
asterisks (*).
Two programming modes have been provided as bellows:
❶ Single-scan setting
Scan the appropriate Single-scan setting (e.g. %0101D00%) according to the user's demand.

Example: to set Flow control to be XON/XOFF.
Steps: Scan the following barcode.
❷ Multiple-scan setting
Step 1. Scan the Option barcode barcode (e.g. %0101M%) according to the user's demand.

Step 2. To the right of the option barcode, the necessary alphanumeric inputs are listed. Scan

two alphanumeric entries from 0 to 9 or A to F, refer to
barcode
.
Step 3. Repeat Step 2, if more user parameters input are required.

Step 4. Scan the %END% barcode, listed on the lower left hand corner of each parameter

setting part.
Example: to set Flow control to be XON/XOFF.
Steps: Scan the following barcodes in order.
14 Configuration alphanumeric entry
19