Saving And Restoring Settings - D-Link DSL-2650U User Manual

DSL-2650U/NRU 3G/ADSL/Ethernet Router
with Wi-Fi and Built-in Switch
User Manual

Saving and Restoring Settings

!
Note that you should regularly save the changes of the router's settings to the non-
volatile memory.
The router's web-based interface displays the notification on unsaved changes at the top of the page.
You can save the router's settings via the top-page menu displayed when the mouse pointer is over
the System caption.
Click the Reboot line if you have already saved the router's settings.
Click the Save&Reboot line to save new settings and immediately reboot the router.
Click the Save line to save new settings to the non-volatile memory and continue configuring the
device. Also you can save the device's parameters via the Save button on the System /
Configuration page.
Click the Backup line and follow the dialog box appeared to save the configuration (all settings of
the router) to your PC. Also you can save the router's configuration to your PC via the Backup
button on the System / Configuration page.
Click the Factory line to restore the factory default settings. Also you can restore the factory
defaults via the Factory button on the System / Configuration page.
Also you can restore the factory default settings via the hardware Reset button located on the
bottom panel of the router.
the device turned on), push, and hold for 5-10 seconds. Release the button and wait until the router
is rebooted (about a minute).
default IP address, username and password.
When you keep the button pushed for more than 10 seconds, the Power LED lights red
!
and the router switches to crash recovery mode. To restore normal operation of the
router, please, contact the Technical Support Service.
When you have configured all needed settings, click the Logout line.
Figure 11. The notification on unsaved changes.
Figure 12. The top-page menu.
Use a small paperclip to activate the button; insert it into the hole (with
Now you can access the web-based interface of the router using the
Page 19 of 107
Installation and Connection