Installing the appliance
Preparing the appliance
Position the appliance in front of the
housing unit.
Fit cover strip into position.
82
Screw fixing bracket using hex
screw to the pre-drilled holes in
the appliance door. Using the pre-
drilled holes in the appliance door,
secure a second pair of fixing
brackets in the handle area of the
door.
Push the appliance two-thirds of the
way into its niche. When doing this,
make sure that the mains cable does
not get trapped.
Tip: To help you push it into position, tie
a piece of string around the plug to
"increase" the length of the connection
cable.
Then pull the cable by the end of the
string through the housing unit. It will
then be easier to connect once the
appliance is in the unit.