Installing The Hairpin Cotter Pins And Washers - Toro 30320 Operator's Manual

5. Check the parking brake adjustment (Fig. 10). Refer to
Checking the Brakes, page 31.
Note: Make sure brake rod is installed in front (F)
mounting hole in idler bracket.
2
3
Figure 10
1. Upper control bar
2. Parking brake lever
1
m–5233
3. Fixed bar
17
Parts needed for this step:
2 Hairpin cotter pins
Installing the Hairpin Cotter
Pins and Washers
Unused height–of–cut spacers may be stored on posts and
retained by a hairpin cotter.
1. On the opposite side of the muffler, install unused
washers and hairpin cotter pins into front and rear
height–of–cut pins (Fig. 11).
3
2
1
Figure 11
1. Hairpin cotter
2. Unused spacers
m-6505
3. Height–of–cut post