Using The Mid-Size Weight Kit - Toro 30320 Operator's Manual

6. Thread rod fitting up or down on rod until proper
position is attained and install into fitting to idler
bracket with clevis pin, washer and hairpin cotter.
Refer to Installing the Control Rods, page 16.
7. Check the parking brake adjustment (Fig. 10). Refer to
Checking the Brakes, page 31.
Using the Mid–Size Weight Kit
A weight kit is available for this machine. This kit is
optional and can be obtain from an Authorized Service
Dealer
The weight kit mounted in the front position is
required when a Tru–Trak Sulky is installed.
The weight kit mounted in the back position is
optional when a Tru–Trak Sulky is not installed
(Fig. 24).
Installing this weight kit can improve performance on
slopes without the Tru–Trak Sulky.
1
3
2
Figure 24
1. Weight mounted in rear
position
2. Capscrew
4
3. Washer
4. Nut
24